Benchmark Games BLASTER Manual page 14

Dual Game Set up
If a Blaster was previously owned and a second Blaster was purchased or if two Blasters were purchased
simultaneously, this section will help physically connect the Blasters and allow the Blasters to compete for a
common Bonus.
If you purchased two Blasters at separate times you will need to contact Benchmark for additional parts
that will be needed to make them compatible.
The parts are as follows:
- If you are combining multiple blasters that have been purchased at different times. Go down to the
heading "COMBINING GAMES FROM DIFFERENT
Game Placement
- Place the Two games side by side. Game A is the Blaster with the Router Board
Present. Game B is the Blaster without the Router Board.
- Game A needs to be to the left of Game B.
- Plug in the power cords to both the Blasters, but DO NOT plug the power cords
into the power outlet. Make sure that the switch for game B is on, so when
plugged in the game will automatically turn on. If you do not place the switch
on before attaching the two games, it will be difficult to reach that switch
again.
- There are two sets of brackets in the cabinet of Blaster
that will physically connect the games.
o The set with the hook ends will be placed on the
front and back of the machine on the bottom
tubing, securing the bottom of the games, (you
will have to unscrew two screws in the bottom of
the game to be able to place the brackets).
PURCHASES"
14