X20; X29 - LinMot E1400-GP-QN Installation Manual

6.14

X20

X20 Analog In (+-10V Differential Analog Input)
RJ-45
6.15

X29

X29 Connector for Fan Option
Connector for the external fan option (Art. Nr. 0150-xxxx).
Output: 24 VDC / 0.4 A (Short circuit protected, current monitored)
Stripping length: 8mm
Conductor cross section: 0.2 – 1.5 mm
6.16 S5
S5 Bus Termination / AnaIn2 Pull Down
S5
NTI AG / LinMot ®
1 Do not connect
2 Do not connect
3 Analog In -
4 GND
5 GND
6 Analog In +
7 Do not connect
8 Do not connect
case Shield
Switch 6: Override Configuration Ethernet to DHCP
Switch 5: Bootstrap: Must be off for normal operation
Switch 4: CAN termination on ME (120R between pin 7 and 8 on X10/X11) on/off
Switch 3: CAN termination on CMD (120R between pin 7 and 8 on X7/X8) on/off
Switch 2: Termination resistor for RS485 on CMD (120R between pin 1 and 2 on X7/X8) on/off
Switch 1: AnIn2 pull down (4k7 Pull down on X4.4). Set to ON, if X4.4 is used as digital output.
Factory setting: all switches "on" except S5.5 (Bootstrap) and S5.6 (Override to DHCP)
www.LinMot.com
E1400 V1 Rev. D Installation Guide
2 (AWG 24 - 16)
Page 15/24