Chapter 3 - Setting Up And Onboarding Devices; Using The Setup Wizard; Using Devicehq For Device Management; System Management (Devicehq) - Multitech MultiConnect MTCAPW-L12G2 Admin Manual

SETTING UP AND ONBOARDING DEVICES
Chapter 3 – Setting Up and Onboarding Devices

Using the Setup Wizard

Note: When using a 4G network, verify a SIM card has been installed before powering on and starting setup.
Configure the device using the web UI. To access the web UI, enter the IP Address into your browser. The default
IP Address is 192.168.2.1. If this has been changed, type in the new IP Address.
From the menu on the left, click Wizard.
1. Wait 60 seconds after connecting power. The computer gets IP address 192.168.2.100 via DHCP.
2. In a web browser, enter IP address 192.168.2.1.
3. Login using admin as both the Username and Password. If you are using the default password, it will
prompt you to change it for future logins.
4. Click Wizard on the left.
5. Click Next.
6. Change password, if desired and click Next. (Recommended)
7. Set the device's Time Zone and click Next.
8. Enter and configure APN.
a. Select Manual Configuration.
b. Set Country to Others.
c. Enter the APN provided by the SIM provider.
d. Click Next.
9. Click Apply.
10. Wait a few minutes and check LED status. Power, SIM, Internet, and Signal LEDs are on when there is a
live Internet connection. For more information on the LEDs, refer to LED Indicators.
After the device has a valid Internet connection, your computer automatically renews to the new IP address
assigned to cellular connection and has full access to the Internet.

Using DeviceHQ for Device Management

DeviceHQ is a cloud-based device management tool for remote monitoring, upgrades, and configuration mPower
devices. For information on creating and using a DeviceHQ account, go to the
http://www.multitech.net/developer/software/devicehq/.
Note: If you are not using DeviceHQ as the management system, disable DeviceHQ as the management system
within the software. Once the Setup Wizard has been completed, from the left menu select Basic Network >
System Management then deselect the "Enable" box on the top row of the configuration table.

System Management (DeviceHQ)

Signing Up with DeviceHQ and Setting Up MTCAPW to Communicate with DeviceHQ

1. Register and sign up a new account at https://www.devicehq.com.
2. Log in to https://www.devicehq.com
12
and generate a device API key using the following steps:
®
MultiConnect CBRS Wi-Fi AP MTCAPW-L12G2 Admin Guide