Motoalliance DENALI MA11704 Manual

Motoalliance DENALI MA11704 Manual

Plow mount

Advertisement

22000 Industrial Blvd Ste 250, Rogers, MN 55374 / 1-866-527-7637
Thank you for purchasing our DENALI plow mount(s). You now own a premium,
custom plow mount to allow you to use your plow with your SxS. Please note the
following instructions and heed all warnings.
• Your UTV/SxS and/or plow system can cause death or injury, please use
caution and common sense when operating your unit.
• Read your Plow Operator's Manual, your Winch Operator's Manual, and all
warning labels before operating your UTV/SxS.
• Operate your SxS at a walking speed with the blade installed. Do not
exceed 5 mph (8 km/h) even with the blade up.
• Do not operate the UTV/SxS on slopes greater than 10 degrees with the
plow installed.
• Always lower the plow to the down position before leaving your UTV/SxS
unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.
866.527.7637
www.motoalliance.com
DENALI Plow Mount
MA11704
'13+ Ranger XP900
'13+ Ranger XP900 Crew
1
motoinfo@motoalliance.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DENALI MA11704 and is the answer not in the manual?

Questions and answers

Summary of Contents for Motoalliance DENALI MA11704

  • Page 1 22000 Industrial Blvd Ste 250, Rogers, MN 55374 / 1-866-527-7637 www.motoalliance.com DENALI Plow Mount MA11704 ‘13+ Ranger XP900 ’13+ Ranger XP900 Crew Thank you for purchasing our DENALI plow mount(s). You now own a premium, custom plow mount to allow you to use your plow with your SxS. Please note the following instructions and heed all warnings.
  • Page 2 MotoAlliance MA11704 22000 Industrial Blvd Rogers, MN 55374 866.527.7637 Please verify that all hardware and parts are included in your package. Kit Content: Please refer to Figure 1 Item Description MA11704-W1 Plow Mount 3/8’’-16 x 1 1/2’’ Serrated Flange Bolt 3/8’’-16 Serrated Flange Nut...
  • Page 3 MotoAlliance MA11704 22000 Industrial Blvd Rogers, MN 55374 866.527.7637 MA11704 Plow Mount Installation 1. Remove the bottom two bolts from the front bumper (See Figure 2), set these aside for later use. Figure 2 2. Hold the plow mount to the bottom of your Ranger XP900 with the tabs facing down and toward the front of the vehicle.

Table of Contents