Configuring Scanner Settings - Fujitsu FI-5000N Getting Started

■ Registering Users
The Administrator can register users on the fi-5000N by
using the fi-5000N Software installed on the Adminis-
trator's PC
New registration of user information
1. From the [Start] menu, select [All Programs] ->
[fi-5000N Software] -> [fi-5000N Configuration
Tool].
2. Select the device name, and click the
[User Config] button.
3. Enter the Administrator PIN (the default setting
is "5000") when you are prompted to enter the
PIN, and click the [OK] button.
⇒
The User Registration screen appears.
4. Select [Add], enter the [User Name], [New PIN],
[Host name/IP address], and click the [Enter]
button.
1
3
⇒
The user is registered in the User List.
2
5. To register more users, repeat Step 4.
6. Click the [Close] button.
Now the users are registered on fi-5000N.

■ Configuring Scanner Settings

The User can configure the scan settings using the
fi-5000N Software and the scanning software installed
on the user's PC.
Configuring Settings on fi-5000N
Software
The fi-5000N Software specifies the application that
starts when the button on the scanner is pressed.
(As an example here, ScandAll 21 is configured to start
when the [Scan] button on the scanner is pressed.)
1. From the [Start] menu, select [All Programs] ->
[fi-5000N Software] -> [fi-5000N Configuration
Tool].
2. Select the fi-5000N unit name, and click the
[Launch Option] tab.
3. Configure the application to start when the
following screen appears.
Button: Selects the configured button
from "Scan" and "Send To 1 ~
Send To 9".
("Scan" is selected here)
(Depending on the selected
button, nothing would occur if
the [Target], [Argument], or
[Start in] are not specified.)
fi-5000N Getting Started
11