Table of Contents
Advertisement
Chapter 1 PREPARING THE DEVICE
1.1 Checking the Contents of
the Device Package
When you open the package containing the fi-5000N,
please handle the main unit and its attachments care-
fully.
Make sure it contains all the parts listed in the package
contents list that is included in the box.
If any parts are missing or defective, contact the store
you purchased the device from.
1.2 Names of Parts
This section describes the device's parts.
■ Front
Sticker
Message Display
LED
Keyboard
■ Rear
Power
Switch
DC Inlet
Security Cable Slot
Finger Guide
Fingerprint Sensor
Finger Sensor
Network
USB connectors
Connector
1.3 Keyboard
The following illustration shows the keyboard located
under the white cover.
This keyboard is used for the following operations:
•
fi-5000N network settings
(administrator rights required)
•
fi-5000N language settings
(administrator rights required)
•
Fingerprint registration
•
Login by PIN
For details about the above operations, see "Chapter 2
INSTALLING THE fi-5000N".
The keyboard is also used for the following operations.
Cover
(For details of these operations, see the "fi-5000N
Operator's Guide".)
•
fi-5000N user PIN setting
•
Displaying the network setting status
•
Displaying the name of fi-5000N on the network
•
Displaying the firmware version
•
Displaying the status of the connected scanner
•
Pull mode user authentication settings
(Administrator rights required)
•
Automatic logout time settings
(Administrator rights required)
•
Message display's backlight automatic light-off
settings (Administrator rights required)
•
Beep sound settings (Administrator rights required)
•
Host connection time-out settings
(Administrator rights required)
•
Initialization of fi-5000N settings
fi-5000N Getting Started
ESC
SET
ENT
1
Advertisement
Table of Contents
