Table of Contents
Advertisement
7. Remove your finger from the fingerprint sensor.
The following screen appears, and the fingerprint
verifications will be repeated twice.
Fingerprint will
be verified twice.
Place your finger
on the sensor
8. For verification procedure, place the finger to
register on the fingerprint sensor again.
If the verification is successfully done, the following
screen appears
First Verification
is successful
9. Second verification starts.
Starting Second
Verification.
Place your finger
on the sensor
10.When the second verification process has been
completed, the following message appears.
Second Verification
is successful
Then the message indicating that the fingerprint data
is being saved is displayed.
Saving fingerprint
data...
Next, the registration completed message appears.
Registration is
successful
OK:[ENT]
Press [ENT] key to finish the registration.
14
2.7 Scan Test
Do an image scan test after configuration.
Scanning from fi-5000N
("Push" mode)
Check whether the image can be scanned successfully
using the below procedures.
•
User Authentication
•
Loading Document
•
Scanning Operation when the scanner button is
pressed
■ User Authentication
To change from the logout status to the ready-to-start
scanning status, fingerprint authentication must be done.
Also, PIN authentication is equipped as an alternative to
an injured users or users with difficulties in fingerprint
authentication.
Authentication by Fingerprint
1. When "Place your finger on the sensor" mes-
sage is displayed, place the registered finger on
the fingerprint sensor.
Place your finger
on the sensor
When you learn to place the finger
correct, you can remove the Finger
HINT
Guide. For the removal, refer to
"Appendix 3 Using User Authentica-
tion By Fingerprint."
When the finger placed on the fingerprint sensor is
detected, the following message appears and the fin-
gerprint capturing begins.
Capturing
fingerprint...
Advertisement
Table of Contents
