Table of Contents
Advertisement
Chapter 2 INSTALLING THE fi-5000N
The scanning test written in section "2.7 Scan Test", is
explained using the FUJITSU TWAIN 32 scanner driver
and the ScandAll 21 scanning application. In order to
perform this scanning test, follow the instructions in sec-
tion "2.4 Installing the Driver", and install the FUJITSU
TWAIN 32 scanner driver and the ScandAll 21 scanning
application.
2.1 Installing the Scanner
Install the scanner following the installation require-
ments described in your fi-series scanner manual.
2.2 Installing the fi-5000N
1. Place the fi-5000N at its installation site.
Install this product near the scanner. Install it in a
place that does not affect the operation or
maintenance of the scanner. Refer to "fi-5000N
Operator's Guide" for details on the specifications of
this product.
2. Connect the AC adapter.
Use only the AC adapter and AC
ATTENTION
cable provided by the manufacturer.
1. Connect the AC cable to the AC adapter.
2) Connect the AC adapter connector to the fi-
5000N's DC inlet.
3) Plug the AC cable into the outlet.
3. Connect the USB cable to the USB connector.
Be sure to use the USB cable pro-
ATTENTION
vided with the scanner.
Correct operation with commercially
available cables is not guaranteed.
4. Connect the other end of the USB interface
cable to the scanner.
The message "Scanner is discon-
ATTENTION
nected" is displayed on the Message
Display of fi-5000N if the scanner is
not connected properly, or if the
power of the scanner is turned off.
Check the connection of the scanner
when it happens. Refer to the scanner
product manual for details on turning
on the power of the scanner.
fi-5000N Getting Started
3
Advertisement
Table of Contents
