Fi-5000N's Network Settings - Fujitsu FI-5000N Getting Started

Fujitsu fi-5000n: user guide
Hide thumbs Also See for FI-5000N:
Table of Contents

Advertisement

2.3 fi-5000N's Network Settings

■ Network Connection
1. Turn on the power of the scanner and fi-5000N.
Refer to the scanner product manual for details on
turning on the power of the scanner.
Turn on the fi-5000N by pressing the "|" of the power
switch located at the back of the fi-5000N.
Power OFF
2. When "The network cable is disconnected"
appears on the fi-5000N's Message Display,
connect the network cable to the network con-
nector at the back of fi-5000N.
The following screen appears.
Obtaining IP address
from DHCP server...
Cancel:[ESC]
If the network support DHCP and the process goes
successfully, "Place your finger on the sensor." mes-
sage appears.
When the above screen remains still,
open the cover of the fi-5000N, and
HINT
press the [ESC] key.
The following screen appears, and
the IP address obtaining operation is
canceled.
Cannot obtain IP
address from DHCP
server.
4
Power ON
Setup:[SET]
■ Language Configuration
With the following procedure, change the language
setting if necessary.
1. Open the fi-5000N's cover and press the [SET]
key.
The following settings screen appears.
Setup
Register Finger
Change PIN Code
Show Network Config
2. With the [ ] key, select "Administrator Setup",
and press the [ENT] key.
The screen to enter the Administrator's PIN
(personal identification number) appears.
PIN:_
Cancel:[ESC]
3. Enter the Administrator PIN (the default setting
is "5000"), and press the [ENT] key.
The following screen appears.
Administrator Setup
Configure Network
Pull Mode Authentic
Auto Logout Time
4. With the [ ] key, select "Change Language",
and press the [ENT] key.
The language selection screen appears.
5. Press the [ ] or [ ] key to select the language
and press the [ENT] key.
The message "selected language changed" appears
and the messages will be displayed at the selected
language.
■ Network Settings
1. Open the fi-5000N's cover and press the [SET]
key.
2. With the [ ] key, select "Administrator Setup",
and press the [ENT] key.
The screen to enter the Administrator's PIN
(personal identification number) appears.

Advertisement

Table of Contents
loading

Table of Contents