Steps Of Configuring Fcoe Boot - Fujitsu PRIMEQUEST 2000 Series Configuration Manual

2. Steps of Configuring FCoE Boot

We explain the steps of configuring FCoE Boot.
In this document, we explain the steps to build FCoE Boot Environment on PRIMEQUEST 2000 series.
For information for setting and adjustment procedure of FCoE storage device and Converged Fabric Switch,
refer to the manuals accompanying to each product.
For information for configuring the server, refer to the manual of the server.
You can get latest version of manual from web site of PRIMEQUEST 2000 series.
Considerations at Introduction
At the time of the introduction of the system, consider following points.
 Before the introduction of the system, check the considerations about SVIM which are described in the
"ServerView Suite Notes".
"ServerView Suite Notes" is posted on the following Web site.
http://jp.fujitsu.com/platform/server/primequest/software/svs/
 When you install OS, you have to install only boot disk for OS. To do so, you must have boot disks
mounted in servers and keep out the other disks from the server.
According to the same reasons, you need to configure ETERNUS so that OS installer recognizes only the
boot disk.
In the case of multi-path configuration, make only a single path (FC cable) connected.
Imｐｏｒｔａｎｔ
After the installation of the system, if there are some changes of configuration as following, initialize the
CNA at first, then reconfigure the CNA, and restart the server.
- In case that you register dump device of SAdump to the CNA.
- In case that you make some configuration change of SAN storage or FCoE switch, e.g. change of LUN
mapping, change of host affinity, change of port zoning, etc.
- In case that you change OS boot path due to some configuration change.
- In case that, for expanding, you register the LUN devices to the CNA.
Copyright 2016 FUJITSU LIMITED 7 CA92344-0966-01