Maintenance
Manually screw in the new filter.
Reset the cock vertically to the O position.
Bleed the fuel system (page 72).
Cleaning the water separator
Open the engine compartment cover (page 74).
Set the cock (3) horizontally to the C position.
Place a cleaning cloth under the water separator to
prevent fuel from spilling on the ground.
Remove the filter cup retainer (1) while holding the cup (2).
Remove the cup.
Empty the cup (4) and clean it with clean diesel fuel.
Replace the sealing ring (2).
Apply a light coat of diesel fuel onto the sealing ring.
Assemble the components in the order shown. Make sure to
insert the floater (1). Tighten the filter cup retainer (3) by
hand. Do not use a tool.
Reset the cock vertically to the O position.
Bleed the fuel system (page 72). Check the water separator
for leaks at the same time.
Draining water from the fuel reservoir
Place a container with a minimum capacity of 25 L under
the fuel drain plug.
Remove the drain plug (1) and drain the water.
Install the drain plug with a new sealing ring on it.
95