Table of Contents
Advertisement
Do not turn the key at this point. If the key is in the
RUN position, turn it back to the STOP position.
7.
The display shows the blinking "Register mode - insert key"
message.
8.
After a brief moment, the display shows the "Finish - pull out
black key" message. This message indicates that the black
key was registered for the given vehicle.
9.
Once the black key is pulled out of the starter switch, the display will show the "Finish - pull out black key"
message.
Follow steps 5 to 8 to register a spare key. Up to four black keys can be registered.
10. Turn the key to the RUN position to finish the registration procedure.
11. One after the other, insert all registered black keys into the starter switch and check whether the engine
can be started using these keys.
If a registered black key is lost, the other black keyes must be re-registered. This procedure locks
the lost or stolen black key, which can no longer be used to start the engine.
80
Operation
Advertisement
Table of Contents
Troubleshooting
