RGBlink SubitoNX S2 User Manual page 19

SubitoNX S2/S4
5. Chip selection:select the chip for the corresponding
module.
Data Type:It is generally to choose parallel driver for
common modules by default (If you would like to
customize some modules needed to select serial data,
please contact with our company.
Module Type: If width of single module is 16, then
choose<Regular light board>. If not, then
choose<Profiled lamp board(with taps)>.
the actual number of:the width of single module
Number of data rows:the height of single module
Number of data line:It can be viewed according to the
number of RBG groups defined by the module
interface.
Line decoding mode:as shown in the left figure
Number of data sets:Conventional and Serial can be
selected.
Cascade direction:Left to right/Right to left/Top to
bottom/Bottom to top
6. Users can remove the√of <state changes
automatically>, and click 1/2/3/4 to change the display
state according to the observation of the LED screen.
For example,click <1>and observe the color of LED
screen,and select <red> if the LED screen shows red.
After all 4 states being done,click <next>
User Manual 19