RGBlink SubitoNX S2 User Manual page 20

SubitoNX S2/S4
1
2
3
8. Select <horizontal or vertical lines> according to the
actual bright line direction of display screen.
Number of bright rows on display:according to the LED
screen
Number of spaced rows:When only one line is lit on the
screen,the number of rows between must be selected.
7. Observe the position of the bright spot on the first
module of the LED screen, and click the corresponding
grid.
If you make a mistake,click <back>to the last step or
<reset> to restart.
If you select <Profiled lamp board(with taps)>in 5th
step,you need to click blank spots.Observe the first
module,and click <unbright spot(blank spot)> if no flash
spot appears.
After the settings, a prompt will pop up. Click <OK> and
then click <Finish> to confirm.
9. After <Smart Settings>,it will return to <Receiving
card>interface and set a new parameters for receiving
cards.
①Fill in the total Width/Height of box.
There is no need to adjust other parameters if the image
of the single receiving card is normal.
② It is recommended to change <grayscale series>and
<low ash effect> to change the refresh rate.
③ Send to receive card: Each time you change the
parameters, you can click <Send to receive card>and
observe the change of the screen.
4
④ Save to the receive card:After debugging,click <Save
to the receiving card>and the data will not be lost after
power off and restart.
User Manual 20