Table of Contents
Advertisement
, and
must be installed.
INSTALLATION – RECIRCULATION MODE
(CAP61CF)
(CAP61CF)
Installing the charcoal filter (CAP61CF)
An activated charcoal filter can be used to trap odours. In order to install the
charcoal filter, the grease filter should be detached first. Press the release button
and pull it downward as shown below.
Fit the activated charcoal filter onto the side of the motor and turn it in a clockwise
direction to lock into place. Repeat the same on the other side.
NOTE:
Make sure the filter is securely locked.
Otherwise, it may loosen and be dangerous.
When using a charcoal filter, the extraction
power may be slightly reduced.
We recommend replacing these filters
every 6 months. Replacement filters
(CAP61CF) can be purchased directly
from www.caple.co.uk
8
Please keep this instruction manual for future reference
14
Instruction manual ZEL900 / ZEL900GM
We recommend replacing these filters every 6 months. Replacement
filters (CAP61CF) can be purchased directly from www.caple.co.uk
If you do not have an outlet to the outside, the
exhaust pipe is not required (as shown in the
section "Installation - ducted"), and charcoal filters
must be installed.
We recommend replacing these filters every 6 months. Replacement
filters (CAP61CF) can be purchased directly from www.caple.co.uk
OPERATION - TOUCH CONTROL
On/Off button
Press and hold for 2-3 seconds to turn the extractor fan on.
You can then change the speeds as per below. Press again to switch off
Low Speed button
Is suitable for simmering and cooking which does not produce much
steam or odour
Medium Speed button
Airflow speed is ideal for extracting with standard cooking
High Speed button
When a high amount of steam or odours are produced, use the high
speed setting for the most effective extraction
Light button
Switches the light on and off.
Instruction manual ZEL900 / ZEL900GM
Please keep this instruction manual for future reference
15
Advertisement
Table of Contents
