Step 5: Verify Operation Of The U5310A Module; Keysight Connection Expert - Keysight Technologies U5310A Startup Manual

Step 5: Verify Operation of the U5310A Module

Keysight Connection Expert

The intention of this step is to verify correct operation of the newly installed module.
Run Keysight Connection Expert by clicking the task bar icon
Connection Expert.
The list of installed modules is displayed. The instrument properties may be viewed by
clicking on the desired instrument from the list on the left.
Review the configuration data and then click on Start soft front panel to launch the
MD2 Soft Front Panel. This will provide control of the module for calibration, test and
other operational verification procedures.
If the module does not appear in the Keysight Connection Expert, first try the
Rescan button. If that does not work, restart your PC or embedded controller and
restart Keysight Connection Expert again.
Keysight U5310A Startup Guide
Step 5: Verify Operation of the U5310A Module
, and select
19