Fitting The Module With The Optional Card Retainer Into Your Pc - Keysight Technologies U5310A Startup Manual

Fitting the module with the optional card retainer into your PC

1. Loosen (but do not remove) the screw (A) holding the rear card retainer, and
slide it towards the fans.
2. Insert the module into the PCIe slot of the PC, ensuring that it is fully seated
into the PCIe bus connector.
3. Fix the module to the PC either by fitting a screw, or by using a method com-
pliant with your PC model.
4. Fully extend the card retainer and ensure that it is inside the PC chassis support
slot.
5. Tighten the screw (A) (0.5 Nm torque).
If the PC is a T5810, the PCIe-card retention (support slots) has to be removed
and adapted by removing two of the extension blocks before inserting the
U5310A. For details, please contact support www.keysight.com/find/assist.
Removing the card retainer
1. Remove the screw (A in the figure).
2. Withdraw the card retainer.
Installing the card retainer (if not previously fitted)
1. Slide the card retainer onto the fan module and fit screw (A) to the top of the
retainer.
Keysight U5310A Startup Guide
Diagram showing U5310A fan and support assembly fixings.
Step 4: Install the Module
15