Table of Contents
Advertisement
Installation Instructions
WALL BRACKET INSTALLATION
FOR ALL UNITS
The Wall Bracket Installation is an essential
part for the correct operation and use of the
Pre Rinse Unit.
1.
Measure and cut the wall support bar (6)
to a length with a 2 to 5mm gap from
the wall.
2.
Fit the "O"-ring (9) to the groove on the
fixing wall plate.(11)
3.
Slide on the chrome cover flange (7), nut
(8), brass olive (10) & wall fixing plate (11)
onto the wall support bar (6).
4.
Swing the wall support bar into position
and mark the three holes for drilling into
the wall.
5.
Swing the wall support bar to the left
or right to enable the three holes to be
drilled.
6.
Swing the wall support bracket back into
position, line up the holes and screw the
fixing plate back to the wall. Tighten the
brass nut and olive, ensuring a firm and
solid installation. Slide the chrome cover
plate over the wall plate.
Note: For a stainless steel splashback and/
or cool room panel wall, ensure the fixing
method used results in a solid fixing.
*
For a masonry wall use the wall anchors
provided (13) with screws (12).
*Regular service must be carried out on the product to avoid product failure.
16
Important Information
•
The wall support bar (6) can
slide up or down to the desired
height
by slowly twisting it back
and forth while moving it in the
desired position.
•
The wall support Bar should
installed as high as possible. This
wall support bar should be cut
to fit the desired distance to the
wall.
•
The side bracket should also be
cut down to the desired length if
it's too long.
*
For a timber backed wall use the screws
provided (12).
be
Advertisement
Table of Contents
