Table of Contents
Advertisement
WALL MOUNTED UNITS
JETF3000, JETF3000W, JETF5600, JETF5000
Pre-rinse arm and pot filler
installation:
1.
Secure the 1/2" BSP male fitting behind
the finished wall.
2.
Flush
the
line
connecting tap fittings. Once the line is
clear of debris, place the Flange(43)
3.
Unscrew the grub screw (18) from the
wall base (42) to separate the main body
(15).
4.
Screw the wall base arm (42) into the
1/2"thread until the unit is tight. Make
sure the wall base is fitted plumb facing
up. Push the flange (43) to cover the
thread.
5.
Insert the pre rinse body (15) into the
wall base arm (42) and tighten the Grub
Screw (18) back in place.
*Regular service must be carried out on the product to avoid product failure.
www.gentecaustralia.com.au
thoroughly
before
Wall Handles Installation:
6.
Unscrew the cover flange (50) from
the main body of the cartridge (1). Also,
unscrew the adjustable locknut (3) from
the Cartridge body. Ensure the fibre
washer (2) is in place.
7.
Screw the cartridge body (1) into the thread
until it touches the seat.
8.
Screw the adjustable locknut (3) until
it reaches the breech (to prevent the
cartridge being overtightened). Replace
the cover flange (50).
9.
Tighten the handles (49) in the desired
position with the provided Allen key(16)
and screws(46). Insert the washers (48 &
47) as shown in drawing.
10.
Insert the plastic indicator (45) for hot,
cold or Warm.
15
Advertisement
Table of Contents
