Table of Contents
Advertisement
Installation Instructions
BUBBLERS
GPT8000, GPT8050, GPT8050UR
For all Units:
1.
Flush water supply pipework prior to installation
2.
It is recommended that an isolating stop valve be installed to facilitate ease of
maintenance
3.
Install the Flow regulator and place the strainer in the inlet connection before screwing the
bubbler to the water inlet.
4.
Connect the bubbler to the water supply
Important Information
We do not recommend dismantling
the internal parts of the bubbler.
The bubbler is individually factory
assembled and tested to give the
best performance.
Service inspections at regular intervals especially in high usage areas will assist in
optimising the operational life of the product.
www.gentecaustralia.com.au
Note: Ensure that thread sealant does not
foul the bubbler inlet, strainer, flow control
and timed flow headwork)
* Failure to do so may restrict or block
the flow regulator affecting the flow
of water.
7
Advertisement
Table of Contents
