Table of Contents
Advertisement
Maintenance
To ensure product's durability:
Regular
service
the
product
To ensure the product's durability it is important to
perform regular cleaning to the nozzle to avoid build up
of grease, dust or any debris.
Once the hose or trigger spray is unscrewed it should
need a replacement for the fiber washer (39)
When not in use, the mixer must be turned off at
the mixer cartridge so the unit is not under main
pressure when unsupervised.
Best practices to keep your unit as
new
•
Installation MUST be by a certified
plumber and adhere to AS3500 and
manufacturer's recommendations.
•
Turn off mixer at base of unit when not in
use to prevent build-up of hot water and
pressure internally.
•
Disassembling riser from mixer base
during installation increases the likelihood
of leaks
•
Trigger spray must be used in an up-
down or sideways motion (following the
motion of the spring and swivel hose).
Bending/ kinking the hose will cause
the stainless-steel braiding to fray and
void warranty.
•
Lines must be flushed before installation
and the strainer and flow regulator
provided must be installed to prevent
debris damaging the cartridges.
18
must
be
carried
to
avoid
product
out
on
failure.
•
Ensure the wall bracket is firmly
attached to the wall to reduce strain on
the riser and mixer fixings.
•
Reduce strain on the product by
installing a pressure limiting valve.
•
Over tightening and cracking product
fixtures is not covered by warranty.
•
The instruction sticker supplied with
the pre-rinse unit must be displayed
in accordance with manufacturer's
recommendation.
Advertisement
Table of Contents
