Advertisement
Instructions
BASIN AND SINK MIXERS
GPN1000, GPN2000D, GPN3500, GPN3500D
Important Note
The mixer must be installed in accordance with the
requirements of the NCC Vol3 and AS/NZS3500 by
a suitably qualified licensed plumber. This product
comes factory assembled and tested for optimum
service life and performance. Water supply lines
1.
Screw in the fixing bolts (15) and tighten
with a screwdriver.
2.
Screw in the two flexible hoses (17).
3.
Place the tap unit in the pre-punched
hole in the sink or basin with the flange
(12) and flexible hoses (17) going first.
*For optimum operational life water pressures between 150kPa and 450kPa are recommended
9
must be thoroughly flushed before connecting the
assembly. Isolating stop cocks should be installed
at the heated and cold water connection points
for ease of servicing. For optimum operational life
water pressures between 150kPa and 450kPa are
recommended
4.
From underneath the basin, fix rubber
seal (13), fixing plate (14) and fixing nuts
(16) with a socket set or a tube spanner to
clamp the mixer onto the basin. Ensure
the tap set is firmly attached.
5.
Connect the mixer to the water supply by
connecting the two flexible hoses to the
isolating stop valves.
6.
After full connection to water supply,
remove aerator and flush out before
initial water test.
7.
Replace the aerator.
Advertisement
