Table of Contents
Advertisement
Installation Instructions
HOB MOUNTED UNITS
JETF1200, JETF1200LP, JETF4000, JETF9900
Important Note
Mixer must be installed to the requirements of AS/
NZS 3500 by a qualified plumber. Your mixer comes
to you already factory assembled and tested.
We do not recommend the dismantling of any
internal part of the mixer. The mixers are factory
tested and sealed to give the best performance
1.
Place the base "O"-ring (33) on the
underside of the mixer body (17).
2.
Screw in the hot and cold flexible
connectors (37) to the mixer body (17)
3.
Place the mixer unit over the pre-
punched tap hole (35mm) in the counter
top. Feed the flexible connectors (37)
through first.
Note: The unit must be installed with
the main mixer handle to the right side
*Regular service must be carried out on the product to avoid product failure.
14
.
.
Pre-punched hole
35mm aprox.
A.
Please flush othoroughly prior to connecting the
new mixer.
B.
All mixers should be installed with isolating
stop cocks
4.
From underneath the counter top,
slide on the U-shaped washer then
the U-shaped fixing plate. (34 & 35)
5.
Screw on the hex nuts (36) until the
mixer base is firmly fixed to the sink.
Tighten with a socket set or tube
spanner.
6.
Connect the hot and cold flexible
connectors to the inlet isolation
valves.
Important Information
for all units
See the detailed wall
•
support instalation on page.
15
See the detailed spring and
•
trigger spray installation on
page 16
Misuse of the product is not
•
covered by warranty.
Pressure exceding 450 kPa
•
will void warranty
Advertisement
Table of Contents
