Imagebuffer - Toshiba BU505MCG Instruction Manual

ImageBuffer

This section describes ImageBuffer control of AcquisitionControl category.
Camera stores images temporarily in image buffer, and read them out in arbitrary timing.
This function is typically used in Random Trigger Shutter mode.
Please refer to TriggerControl section as well.
● Registers
Register
ImageBufferMode
ImageBufferFrameCount
ImageBufferRead
● Setting
- Activate trigger mode
Set "On" to "TriggerMode" register, and set "TriggerSoftware" or "Line0", "Line2" to "TriggerSource"
register.
- Activate image buffer mode
Set "On" to "ImageBufferMode" register.
- Open/Close stream channel (to be ready to receive stream data)
Set "1" to "StreamEnable" in Bootstrap Registers before "ImageBufferRead".
Set "0" to "StreamEnable" in Bootstrap Registers after completion of image acquisition from image buffer.
- Capture and store images
Input trigger signals to capture and store images.
"ImageBufferFrameCount" register shows the number of frames stored in the buffer.
The maximum number of frames storable depends on the image size. (maximum 64MByte.)
- Set the number of frames to transfer (In ImageBuffer mode)
Set the number of frames to transfer to "AcquisitionFrameCount". Setting value is Integer type.
- Read images from the buffer
Read the number of AcquisitionFrameCount image(s) from the buffer by executing "ImageBufferRead"
register command (it is equivalent to write value 10 to "AcquisitionCommand" register).
Copyright © 2016 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility Access
Beginner R/W Selects Image Buffer mode.
Beginner R Returns the number of frames stored in the buffer.
Beginner W Executes the image buffer read.
50 / 92
Description
D4253386C
http://www.toshiba-teli.co.jp/en/