Maintenance
There is no periodic or routine maintenance required.
Cleaning
WARNING: BEFORE CLEANING WITH A DAMP CLOTH, DISCONNECT OR UNPLUG THE STAND FROM ANY POWER
SOURCE.
CAUTION: DO NOT USE SOLVENTS OR STRONG CLEANING SOLUTIONS ON ANY PART OF THE ADVANTAGE PLUS
CHAIR & STAND OR DAMAGE TO THE UNIT MAY OCCUR.
Clean the external surfaces of this instrument using a clean, soft cloth moistened with a mild detergent
solution (1 cc of liquid dish soap to one liter of clean, filtered water (filtered below 5 microns)).
Troubleshooting
If your Stand does not function at all:
1. Check your facility power source. Is the outlet "live"?
2. Check your electrical connections.
WARNING: TO HELP PREVENT THE POSSIBILITY OF ELECTRICAL SHOCK, ALWAYS UNPLUG THE STAND BEFORE
REMOVING OR REPLACING THE FUSES.
3. Check the Fuses located on the Power Input Panel.
If the Overhead Lamp does not light:
1. Check the Stand Main ON/OFF Switch.
2. Check the ON/OFF Switch on the Overhead Lamp.
WARNING: THE BULB MAY BE HOT! ALLOW TO COOL BEFORE REMOVING.
3. Replace the halogen bulb. (P/N 15253-002-021)
Accessories
•
Non-counterbalanced Keratometer Arm (P/N 15255)
•
Counterbalanced Keratometer Arm (P/N 15254)
Projector Arm Mount (P/N 15258)
•
Touch up paint kit (P/N 15259)
•
Endurance Tilt Chair and Stand User's Guide 15250-101 REV-A
23