Table of Contents
Advertisement
Installation And Assembly
3. Slide the white rod collar down to the base of the pole and tighten the allen key to hold it
in place.
Optional Third Arm Installation
1. Slide the safety collar down the pole to the desired position for the Third Arm and tighten the
allen key to secure it in place.
2. Slide the Third Arm down over the vertical post to the desired location and tighten the locking
ring allen screw.
3. Remove the cover over the auxiliary power panel and plug the the Third Arm power cord into
the outlet labeled ACC.
Refractor Arm Assembly
1. Slide the safety collar for the Refractor Arm down the mounting pole into the desired position
and tighten the allen key with the 5/32 wrench.
2. Slide the Refractor Arm (with the lock ring to the bottom) down the vertical post to the desired
position and tighten the lock handle to secure it in place.
3. Slide the white refractor bearing collar down the pole until it is in place over the refractor arm
mount.
4. Slide the refractor mounting bar into the Refractor Arm and tighten in place.
5. Any exposed wires from auxiliary instruments can be concealed in the refractor arm by pulling
up the wire cover strip, feeding the wire into the slot in the arm, and replacing the cover strip.
B
A
16
C
D
(continued)
C. Rod collar and key
A. Refractor arm safety collar
B. Refractor arm lock handle
C. Refractor mounting bar
D. Wire cover strip
C
Endurance Tilt Chair and Stand User's Guide 15250-101 REV-A
Advertisement
Table of Contents
