Chair And Stand Set-Up; Operation; Lower Instrument Arm - Ametek Reichert Endurance Tilt Chair and Stand User Manual

Installation And Assembly
Chair Set-Up
1. Connect the power cords to the stand and the chair and plug them into outlets.
2. Connect the Chair Power/Control Cord to the stand and the chair.
3. Connector the Foot Switch to the connector on the chair base.

Operation

Lower Instrument Arm

There are three locking handles on the lower instrument arm: one that controls the position of the lower section
of the arm, one that controls movement of the upper section of the arm, and one that tightens and loosens the
slit lamp table. Turn the locking handles to the right to tighten and hold the arm in position, and turn them coun-
terclockwise to loosen the handle and move the arm into a different position.
Press the release latch in the upper section of the arm to raise and lower the entire arm.
A
B
A
Endurance Tilt Chair and Stand User's Guide 15250-101 REV-A
C
D
Refractor Arm
The position of the refractor arm can be raised or lowered
by releasing the locking handle. Push the handle away from
yourself to release it. Pull the handle toward yourself to lock
the refractor arm in place.
(continued)
A. Locking handle of the lower
E
section of the arm (not shown)
B. The chair moves up and down
from this pivot point.
C. Lower arm release latch
D. Locking handle for the upper
section of the arm
E. Slit Lamp table locking handle
A. Refractor arm locking handle
19