Table of Contents
Advertisement
Operation
Chair UP/DOWN Switch
Press and hold the UP Arrow to raise the chair. Press and hold the DOWN Arrow to lower the chair.
Press the AUTO button for Auto-Down mode.
Note: The Chair can be operated from the Foot-Switch or Lower Arm Switch as well.
Lower Instrument Arm ON/OFF Switch
The S.L. Switch is a push type on-off switch to control the electricity to the outlet on the Lower Instrument
Arm. If the switch is off, depressing it once will turn it on and apply power to the outlet on the Lower
Instrument Arm. If the switch is on, depressing it once will turn the switch off. An LED just to the left of
the switch illuminates to indicate the switch is on.
Chart Projector ON/OFF Switch
The C.P. Switch is a push type on-off button. It controls the electricity to the C.P. Outlet on the lower left of
the Auxiliary Power Panel. If the switch is OFF, pressing the switch once will turn it on. If the switch is on,
pressing the switch once will turn it off. An LED just to the left of the switch lights up when the switch is ON.
Accessory ON/OFF Switch
The ACC Switch is a push type on-off switch. It controls the electricity to the ACC Outlet on the left of the
Power Input Panel when facing the back of the stand. If the switch is OFF, pressing the switch once will
turn it ON. If the switch is ON, pressing the switch once will turn it OFF. An LED just to the left of the switch
lights up when the switch is ON.
Charging Wells
CAUTION: DO NOT ATTEMPT TO STORE HANDLES THAT USE ONLY ALKALINE BATTERIES IN THE CHARGING
WELLS OR DAMAGE TO THE CHARGING WELLS OR HAND-HELD INSTRUMENTS MAY OCCUR.
The Charging Wells are designed for hand-held instruments with a rechargeable battery. The Charging
Wells will charge instrument batteries as long as the instrument handle is fully inserted in the well.
There is a Charge Indicator Light beneath each well that indicates an instrument is properly seated
and charging.
Note: Your hand-held instruments must be turned OFF prior to placing them in the Charging Well.
Additionally, the Stand Main ON/OFF Switch must be ON for the instrument batteries to charge.
20
(continued)
Control Panel
The Control Panel (See page 15 for Control Panel diagram) contains all of the
electrical controls except
(1) the Main Power ON/OFF Switch, (2) a secondary Chair UP/DOWN Switch and
(3) the Lower Arm Vertical Motion Switch.
Main ON/OFF Switch
Located on the bottom left corner of the back of the stand the Main ON/OFF
Switch controls the electric power for the entire stand. This switch is a rocker type.
Press the side with the straight line "I" to turn the stand ON. You will hear
a beep that indicates the stand is energized. Press the side with the circle "O"
to turn the stand OFF.
Endurance Tilt Chair and Stand User's Guide 15250-101 REV-A
Advertisement
Table of Contents
