Ametek Reichert Endurance Tilt Chair and Stand User Manual page 22

Operation
Chair Operation
22
(continued)
(continued)
A
B
C
Main ON/OFF Switch
Located on the bottom right corner of the back of the chair the
Main ON/OFF Switch controls the electric power for the chair.
This switch is a rocker type. Press the side with the straight
line "I" to turn the stand ON. You will hear a beep that indicates
the chair is energized. Press the side with the circle "O" to turn
the chair OFF.
To raise the chair press the up arrow on the Foot Switch, the
up arrow in the CHAIR section of the Control Panel, or the
UP Switch on the Lower Instrument Arm. Press the down
arrow on the Foot Switch, the down arrow in the CHAIR
section of the Control Panel, or the DOWN Switch on the
Lower Instrument Arm to lower the chair incrementally. Press
the Auto-Down button to lower the chair to the lowest position.
A. Head Rest
The Head Rest can be positioned by pulling the Lock
Handle to the unlocked position, positioning the Head Rest
in the desired position and squeezing the handle until it
snaps into the locked position.
B. Chair Tilt
The Chair Tilt can be positioned as required by squeezing
the bar at the top back of the chair and positioning the
patient in the desired degree of tilt. When the bar is
released, the chair will lock into position. Slowly raise
and lower the chair to the desired position.
C. Chair Rotation
The release and lock lever for chair rotation is located at the
bottom rear of the chair. Pull up with your foot to release the
lock. Push down with your foot to lock the chair in position.
Arm Rests
The Arm Rests can be positioned in the vertical or
horizontal position as desired.
Foot Rest
The Foot Rest can be positioned in the upright or horizontal
position as needed.
Endurance Tilt Chair and Stand User's Guide 15250-101 REV-A