Vertical Post Assembly - Ametek Reichert Endurance Tilt Chair and Stand User Manual

Installation And Assembly
3. Place the needle bearing assembly on top of the arm port before installing the slit lamp.
4. Using the 5/32 allen key, adjust the instrument leveling set screws as needed to level the table
when installing the slit lamp. There are six screws located in the front and on each side of the
slit lamp port.
Installing the Mounting Pole
1. Open the back of the lower section of the stand by removing the six screws that hold the panel
in place. The back panel is notched at the bottom so slide it up and out of position to remove it.
2. Insert the pole into the opening at the top of the stand and align the notch at the bottom of the
pole with the pins at the base of the pole support.
Endurance Tilt Chair and Stand User's Guide 15250-101 REV-A
H
G
G
A
B
B
(continued)
G. Slit lamp leveling set screws
H. Ø ¾ needle bearing assembly
A. Rod Notch
B. Pins
15