Safety Precautions - Infineon iMOTION EVAL-M1-099M-C User Manual

EVAL-M1-099M-C User Manual
iMOTION™ Modular Application Design Kit

Safety precautions

1 Safety precautions
In addition to the precautions listed throughout this manual, please read and understand the following
statements regarding hazards associated with development systems.
Table 1 Precautions
Attention: The ground potential of the EVAL-M1-099M system is biased to a negative
DC bus voltage potential. When measuring voltage waveform by oscilloscope, the
scope's ground needs to be isolated. Failure to do so may result in personal injury or
death and equipment damage
Attention: Only personnel familiar with the drive and associated machinery should
plan or implement the installation, start-up and subsequent maintenance of the
system. Failure to comply may result in personal injury and/or equipment damage.
Attention: The surfaces of the drive may become hot, which may cause injury.
Attention: EVAL-M1-099M system contains parts and assemblies sensitive to
Electrostatic Discharge (ESD). Electrostatic control precautions are required when
installing, testing, servicing or repairing this assembly. Component damage may
result if ESD control procedures are not followed. If you are not familiar with
electrostatic control procedures, refer to applicable ESD protection handbooks and
guidelines.
Attention: A control board, incorrectly applied or installed, can result in component
damage or reduction in product lifetime. Wiring or application errors such as under
sizing the motor, supplying an incorrect or inadequate DC supply or excessive ambient
temperatures may result in system malfunction.
Attention: Remove or connect this control board from or to the power drive. Wait
three minutes after removing power from the power drive to discharge the bus
capacitors. Do not attempt to service the drive until the bus capacitors have
discharged to zero. Failure to do so may result in personal injury or death.
Attention: EVAL-M1-099M system is shipped with packing materials that need to be
removed prior to installation. Failure to remove all packing materials which are
unnecessary for system installation may result in overheating or abnormal operating
condition.
Application Note 2 <Revision 1.0>
<2017-08-21>