Table of Contents
Advertisement
Press again the Escape key until the working screen.
6.5.3
Mains frequency
If the power supply of the converter is AC, the following screen will appear:
Normally "Automatic" should be selected. In this case, the computer automatically detects
the frequency of the mains and thus uses the most appropriate coil excitation to eliminate
noise from the mains.
The detected frequency can be shown in the screen that appears when you select the
automatic mode.
If manual mode is selected, the mains frequency can be chosen between the two most
prevalent in all countries, 50 and 60 Hz
If the power supply of the converter is DC, this screen appears directly.
6.5.4
Coil current
In normal situations it is not necessary to change the coil current selected in the equipment
by default.
NOTE: So that this change is effective, several jumpers inside the instrument need to be
changed. In case that a different coil current must be used, please contact us.
32
Advertisement
Table of Contents
