Table of Contents
Advertisement
Network Computing Platforms
2. Open the lock outwards.
3. Pull the drive bay out and install a 3.5" SATA disk drive. Please keep in mind that the SATA
connector of your SATA disk drive should point to the inside of the system.
Replacing Front Network I/O Blades & Switch Boards
The system provides a total of six externally accessible LAN I/O blades and/or switch boards,
varied depending on ordering configurations (the system supports up to 2 switch boards and
up to 5 LAN I/O blades). To replace a new blade/board, please follow the steps below.
1. Rotate and loosen the two captive screws at both ends. You may use a screwdriver to
conduct this task.
Advertisement
Table of Contents
