Installation Of Outdoor Unit - Whirlpool ASV09000R Installation Manual

Installation of outdoor unit

(select it according to the actual installation situation)
1. Select installation location according to the house structure.
2. Fix the support of outdoor unit on the selected location with expansion screws.
Note:
installing the outdoor unit.
● Make sure the support can withstand at least
four times of the unit weight.
● The outdoor unit should be installed at least
joint.
● For the unit with cooling capacity of 2300W
~5000W, 6 expansion screws are needed;
for the unit with cooling capacity of 6000W
~8000W, 8 expansion screws are needed;
for the unit with cooling capacity of 10000W
~16000W, 10 expansion screws are needed.
Step two: install drain joint
( O n y l f r o c o l o
unit)
1. Connect the outdoor drain joint into
the hole on the chassis, as shown in
the picture below.
2. Connect the drain hose into the drain
vent.
drain vent
Drain hose
n i g a n d h e t a
chassis
outdoor drain joint
at least 3cm above the floor
n i g
1. Place the outdoor unit on the
support.
2. Fix the foot holes of outdoor unit
with bolts.
37
foot holes
foot holes