Whirlpool ASV09000R Installation Manual page 14

Introduction for buttons on remote controller
Note:
For preventing cold air, after starting up heating mode, indoor unit will delay
1~5 minutes to blow air (actual delay time is depend on indoor ambient
temperature).
Set temperature range from remote controller: 16~30℃ (61-86℉);
Fan speed: auto, low speed, low-medium speed, medium speed, medium-high
speed, high speed.
FAN button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, ,
Low speed
Note:
It's Low fan speed under Dry mode.
X-FAN function: Hold fan speed button for 2s in COOL or DRY mode, the icon "
is displayed and the indoor fan will continue operation for a few minutes in order
to dry the indoor until even though you have turned off the unit. After energization,
X-FAN OFF is defaulted. X-FAN is not available in AUTO, FAN or HEAT mode.
This function indicates that moisture on evaporator of indoor until will be blowed
after the unit is stopped to avoid mould.
• Having set X-FAN function on: After turning off the unit by pressing ON/OFF
button indoor fan will continue running for a few minutes. at low speed. In this
period, Hold fan speed button for 2s to stop indoor fan directly.
• Having set X-FAN function off: After turning off the unit by pressing ON/OFF
button, the complete unit will be off directly.
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode."
exit turbo function and "
If start this function, the unit will run at super-high fan speed to cool or heat quickly
so that the ambient temp. approachs the preset temp. as soon as possible.
5
button
Press " " or "
Holding " " or "
will change quickly. On releasing button after setting is finished, temperature
indicator on indoor unit will change accordingly. (Temperature can't be adjusted
under auto mode)
to , then back to Auto.
Auto
Medium-High speed
" icon is displayed on remote controller. Press this button again to
" icon will disappear.
" button once increase or decrease set temperature 1℃ (℉).
" button, 2s later, set temperature on remote controller
Low-Medium speed
11
Medium speed
High speed
,
"