Advertisement
foam backed abrasive pad, it is NOT suitable for use as a sanding abrasive. DO NOT USE
THE SANDER WITHOUT A PROPER ABRASIVE PAD INSTALLED (to prevent severe damage to
the work).
4). Position new abrasive pad to the back-up disc, making sure that the center hole in the
abrasive disc is centered on the hub of the back-up disc.
5). Position the large metal washer the retaining nut to the Sander.
6). Rotate the retaining nut clockwise to hand tighten (while holding the abrasive pad).
5, Maintenance
Kept clean tools, clean up debris and dust.
Often change grease (gearbox, the bearing) holding tool flexible operation.
Always check the power cord, plugs, switches, etc., the tool in good condition.
This tool passed rigorous quality inspection, if the machine is still a failure occurs, please
send it to an authorized customer service (SWAP) for repair.
If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
Store the tool and accessories in a dry place, out of reach of children.
6, ENVIRONMENT
Electrical products should not be discarded with household products.
According to the European Directive 2012/19/EU on waste electrical and
electronic equipment and its implementation into national law, electrical
products used must be collected separately and disposed of at collection
points provided for this purpose. Talk with your local authorities or dealer for advice on
recycling.
12
ORIGINAL INSTRUCTION >EN
Advertisement
