Advertisement
ORIGINAL INSTRUCTION >EN
TO START AND STOP DRYWALL SANDER
Make sure power circuit voltage is the same as shown on the specification plate on the
Sander, and that the sander switch is OFF. Connect Sander to power circuit.
The Drywall Sander is equipped with finger touch switch. Please see as below picture
shown:
To connect with electric power by press power key, then press ON/OFF key to turn on the
machine. And press again ON/OFF key to turn off machine. And Power cut by pressing
POWER key.
SPEED CONTROL
The Drywall Sander is equipped with a variable speed control. The speed is adjusted by
"+","-"
from numbered "1" through "7" with "1" being the slowest speed (approximately
900 RPM)and "7" being the fastest speed {approximately 2100 RPM).Use the higher speed
settings for fast stock removal. Use the lower speed selling to reduce removal rate for
more precise control
BRUSH-TYPE SKIRT
A brush-type skirt surrounds the abrasive pad. This skirt serves two purposes: (1) the skirt
extends below the surface of the abrasive pad so that it contacts the work surface first.
This position the sanding head parallel to the work surface before the abrasive contacts
the work, preventing the abrasive from "gouging" the work. (2) The skirt also helps contain
the drywall dust until the vacuum cleaner pulls it away.
CAUTION: DISCONNECT SANDER FROM POWER CIRCUIT.
To replace skirt: (1) Remove abrasive pad (see ABRASIVE PAD REPLACEMENT). (2) Use
Phillips screwdriver to remove the six retaining screws (3) Lift the skirt out of housing. (4)
Position new skirt to housing and install the six retaining screws. (5) Replace the abrasive
pad.
10
Advertisement
