Maintenance - Stanley SPT500 Original Instructions Manual

Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Stanley Service centre in
order to avoid a hazard.
The extension cable must be suitable for outdoor use and
marked accordingly. Up to 0.75 mm² H05VV-F or H05RN-F
extension cable can be used without loss of product
performance.
Features
This tool includes the following features:
1. Nozzle
2. Blast Port
3. Trigger Switch
4. Lock-On Button
5. Suction Port
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplug.
Use
Mounting The Nozzle For Blowing Operations (fig. A)
• Insert the pin located inside the Nozzle into the notch
provided on the Blast Port (1)
• To lock Nozzle in place, turn the Nozzle in the direction
indicated.
• To remove Nozzle, turn the Nozzle in the opposite
direction.
Operating The Blower (fig. B)
• To switch your Blower on, depress the Switch (3). To
stop your Blower, release Switch.
• When continuous operation is required, first depress the
switch and then the lock-on button (5) and release to
disengage lock, squeeze and release switch.
(Original instructions)
Warning: Continuous running of machine should not exceed
30 minutes.
Replacing Carbon Brushes (fig. C)
• Use a screwdriver to remove the brush holder cap.
• Take out the worn carbon brush, insert the new one and
secure the brush hold cap.
Warning! Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Accessories
The performance of your tool depends on the accessory
used. STANLEY and Piranha accessories are engineered to
high quality standards and designed to enhance the
performance of your tool. By using these accessories you
will get the very best from your tool.

Maintenance

Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous
satisfactory
operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance, switch off
and unplug the tool.
• Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Technical data
Voltage
Frequency Hz
Power W
No-load speed /min
Air Volume m /min
3
Weight Kg
ENGLISH
SPT500
V 220 - 240
50/60
500
16,000
3.5
1.6
5