Maintenance - Stanley SXPG42603 Manual

ENGAGE AIR BLOWING
Air blowing will be engaged if the operator presses the throttle
trigger to increase the engine speed.
TIPS FOR WORKING
To keep from scattering debris, blow around the outer edges of
a debris pile. Never blow directly into the centre of a pile.
Operate power equipment at reasonable hours only - not early
in the morning or late at night when people might be disturbed.
Comply with the times listed in local ordinances.
To reduce sound levels, limit the number of pieces of equipment
used at any one time.
CLEANING AND CARE
Correct and regular cleaning is not only important for the safe
use of this product, but also extends its life span.
WARNING.
Always stop the engine and wait for the
engine to cool down.
Please remove dust, grass etc. from machine after every
application. Clean the machine with a wet cloth. For cleaning
difficult to reach areas, use a brush.
You may use pressurised air to remove persistent dust.
NOTE: Do not use chemical, acid, alkaline, grinding or other
aggressive cleaning agents. They could destroy the surface of
the product.

MAINTENANCE

WARNING.
Always stop the engine and wait for the
engine to cool down.
Disconnect spark plug wire and move it away from
spark plug.
When servicing, use only identical replacement parts. Use of
any other parts could create a hazard or cause product damage.
Always wear eye protection with side shields marked to comply
with Australian Standards, along with hearing protection.
Failure to do so could result in objects being thrown into your
eyes and other possible serious injuries.
OPERATION
Conserve water by using power blowers instead of hoses for
many lawn and garden applications including areas such as
gutters, screens, patios, grills, porches, and gardens.
Operate blower at the lowest possible throttle speed to do the
job. Check your equipment before operation, especially the
muffler, air intakes, and air filters.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water is
available.
Watch out for children, pets, open windows, or freshly washed
cars, and blow debris safely away.
After using blowers or other equipment, CLEAN UP! Dispose of
debris properly.
MAINTENANCE
INSPECTION AND MAINTENANCE
SCHEDULE
The maintenance interval is only a recommendation for
machines in ordinary operating condition. If there are any
abnormal signs from the machine, please do the proper
inspection and maintenance immediately.
The tightening torque should follow the general screw
specification of different size, class and material.
If anything is unclear to you, please contact our service team for
help. See Page 3 or 5 for contact details.
All other repairs or maintenances which are not mentioned here
shall only be done by our service team or authorised personnel.
14