Package Contains; Maintenance - Stanley SPT500 Original Instructions Manual

ENGLISH (
Original Instructions)
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the
user must read the instruction manual before
use.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2021 XX ZX
Year of manufacturing

PACKAGE CONTAINS

The package contains:
1 Blower
1 Nozzle
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig A)
WARNING: Never modify the power tool or any
part of the tool, otherwise it may cause damage
to the tool or result in personal injury.
1. Nozzle
2. Blast Port
3. Trigger Switch
4. Lock-On Button
5. Suction Port
16
Direct Current
n No-Load Speed
0
Class II
Construction
Earthing
Terminal
Safety Alert
Symbol
Revolutions or
/min. Reciprocation
per minute
ASSEMBLY
WARNING: Before assembly, make sure that the
tool is switched off and unplug.
Mounting The Nozzle For Blowing Operations (fig.A)
1. Insert the pin located inside the Nozzle into the
notchprovided on the Blast Port (1)
2. To lock Nozzle in place, turn the Nozzle in the direction
indicated.
3. To remove Nozzle, turn the Nozzle in the opposite
direction.
Operation
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk of serious
personal injury, turn tool off and disconnect
tool from power source before making
any adjustments or removing/installing
attachments or accessories.
Warning: The voltage of the power source must match
the voltage specified on the rating plate of the power
tool.
Warning: Never attempt to work with the power tool
held upside down. This is dangerous and can lead to
serious accidents.
Operating The Blower (fig.B)
1. To switch your Blower on, depress the Switch (3). To
stop your Blower, release Switch..
2. When continuous operation is required,first depress the
switch and then the lock-on button (5) and release to
disengage lock, squeeze and release switch..
WARNING: Continuous running of machine
should not exceed 30 minutes.
Replacing Carbon Brushes (fig.C)
1. Use a screwdriver to remove the brush holder cap.
2. Take out the worn carbon brush, insert the new one and
secure the brush hold cap.
WARNING! Remove and check the carbon
brushes regularly. Replace when they wear down
to the limit mark.

MAINTENANCE

Your STANLEY tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
WARNING! To minimize the danger of serious
personal injury, please switch off the tool power
and disconnect all plugs before adjusting or
removing/ installing any accessory. Before
reassembling the tool, press and release the
trigger switch to make sure the tool is already
switched off.
WARNING! Before performing any maintenance
on corded/ cordless power tools: