Table of Contents
Advertisement
3. Installation
Figure 3.4 Inverter handles
WARNING
Due to the weight of the inverter, contusions or bone fractures could
occur when incorrectly lifting and mounting the inverter. When mounting
the inverter, take the weight of the inverter into consideration. Use a suitable
lifting technique when mounting. When installers are carrying the inverter,
please use 4 handles to secure safety. Lifting force of each handle shall not
exceed 1.5 times of the inverter weight.
In case of using hoisting to lift the inverter, fix the hoisting cable to the hanger shown in the
graph. Please make a reasonable selection of hoisting equipment considering the inverter
weight of 113kg/249lb.
Figure 3.5 Hoisting sketch
.12.
3.3 Mounting the Inverter
The inverter can be mounted to the wall or metal array racking. The mounting holes should be
consistent with the size of the bracket or the dimensions shown in Figure 3.6.
Φ11mm(0.43in)
Figure 3.6 Inverter wall mounting
3.3.1 Wall mounting
This product is designed for utility scale power plant application, not for commercial and
industrial rooftop application. This product only support 90° angle vertical mounting
installation. The steps to mount the inverter are listed below.
1. Refer to Figure 3.7, drill holes for mounting screws based on the hole diameter of
bracket using a precision drill keeping the drill perpendicular to the wall.
Max depth is 3.6 in.
2. Make sure the bracket is horizontal. And the mounting holes are marked correctly.
Drill the holes into wall at your marks.
3. Use the suitable mounting screws to attach the bracket on the wall.
4. Lift the inverter and hang it on the bracket, and then slide down to make sure they
match perfectly.
Inverter hook
Figure 3.7 Install the inverter
3. Installation
1026mm(40.39in)
970mm(38.18in)
Torque:22.1-25.8 ft.lbs
.13.
Advertisement
Table of Contents
