Mounting The Inverter - CanadianSolar CSI-25K-T400 Series Installation And Operation Manual

5. Installation
Vertical
√
Inverted
×
Install on a vertical surface or structure capable of bearing the weight.
Please install the inverter vertically. If the inverter cannot be mounted vertically, it may
be tilted backward to 15 degrees from vertical.
When multiple inverters are installed on site, a minimum clearance of 500mm,should be kept
between each inverter and any other mounted equipment. The bottom of the inverter must
be at least 500mm from the ground or floor. See figure 5.2.
Visibility of the LED status indicator lights and LCD display screen should be considered.
500mm
Figure 5.2 Inverter Mounting clearance
.10.
Backward
≤15°
500mm
500mm
500mm

5.2 Mounting the Inverter

Bracket size:
√
×
Refer to figure 5.4 and figure 5.5. Inverter shall be installed vertically.
The steps to install the inverter are listed below.
1. Refer to Figure 5.4, use the bracket as a template and drill the four holes accordingly.
(Diameter=10mm, Depth=60mm).
2. Make sure the bracket is horizontal.
3. Use suitable expansion screws to fix the bracket on the wall.
(Diameter=10mm, included in the package.)
5. Installation
1
3
Figure 5.3 Inverter wall mounting
Bracket
Suitable fixing screws
Figure 5.4 Inverter wall mounting
2
4
.11.