Table of Contents
Advertisement
6.0 Installation Guide
6.5.1 Drill Blocks
The wood blocks are inserted in the table slot as shown in Figure 3. The blocks should be flush with
the table top, shim if necessary. The blocks can be turned around and over when worn.
6.5.2 Mounting Drill Heads
The drill heads are inserted as follows:
1. Locate the plastic cover on the right hand side of the machine. Loosen the front knob and rotate
cover back to expose lock knob. (See Figure 4)
WARNING: DO NOT use this machine without having the guard shown in fig. 4 is in place.
14
Figure 3
Figure 4
Advertisement
Table of Contents
