fantastic furniture Hamilton Queen bed Manual page 26

Step 5
You will need
1 x Dowel 1 x Cam Bolt
(H1) (H3)
1 x Cam Nut Phillips head
(H4) screwdriver
Flat head
screwdriver
Attach 1 x Cam Bolt (H3) into Rail (P6) as shown.
Insert 1 x Cam Nut (H4) into the hole of Divider (P7).
Rotate the cam nut so the arrow point towards the incoming cam bolt.
Attach Divider (P7) to Rail (P6), then tighten the cam nut using a Flat head screwdriver.
Insert 1 x Dowel (H1) into the hole of Divider (P7), then attach Rail (P4) to Divider (P7) as shown.
Step 6
You will need
4 x Cam Nuts Flat head
(H4) screwdriver
Insert 4 x Cam Nuts (H4) into the holes of Rails (P5).
Rotate the cam nuts so the arrows point towards the incoming cam bolts.
Attach Rails (P5) to Divider (P7), then tighten the cam nuts using a Flat head screwdriver.
www.fantasticfurniture.com.au
(P4)
H1
Cam Nut hole
nearby bottom
(P7)
(P5)
(P7)
H4
This is how a cam nut works ........
H4
H4
H3
(P6)
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
(P5)
H4
H4
PAGE 7