Table of Contents
Advertisement
Change the direction of the drain hoses
Figure 1 shows the factory installation position of the drain hose.
Extend the drain hose from the spin tub side:
1.Remove the drain hose from the hanging hole on the cabinet.
Pull the drain hose fixing hook outwards gently to take out the
drain hose from the two fixing hooks.(See Figure 2.)
2.Turn 90° the drain hose fixing hookto remove it from the
installation hole.(See Figure 3.)
3.Install the two drain hose fixing hooks taken out,into the
installation hole at the other side of the base frame (to aim
at the installation hole accurately you can lean the washing
machine forward slightly).Then turn 90°.(See Figure 4.)
Install the water intake hose
Insert the water intake
into the water-inlet entrance
on the control panel.
Add water as necessary.
hose
Water intake hose
Water inlet
6
Advertisement
Table of Contents
