Installation And Adjustment - Candy RTT 261WSU-19 User Manual

Installation and adjustment

For your security and to ensure correct operation of the machine, please install and
adjust the machine according to this manual's instructions.
Installation of the lint filter
Place the bottom side of the lint filter into the
overflow filter, then push the top side into the
overflow filter.
After installation, please double check
sure that the lint filter is installed in the correct
location; otherwise it may fall off during operation.
(on models RTT 2101WSU-19,RTT 2111WS-19)
After unpacking your washing machine,take out the
lint filter from the documentation bag.
Install the lint filter in the overflow filter located inside
the washing tub.See the illustration.
(on models RTT 261WSU-19,RTT 271WS-19)
Drain hose usage
Drain hose drainage should be smooth and unobstructed.
1.The height of the drain hose shall be
less than 10cm, or the drainage will
not be smooth enough and cause
incomplete drainage.
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
4.If extra drain hose is needed, please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm,and the
length shall not exceed 1.5m.
If the extra hose is too long, cut it either
at point A or B.
5
to make
overflow filter
lint filter
overflow filter
lint filter