Candy RTT 261WSU-19 User Manual page 14

Cleaning the overflow filter
Too much lint in the overflow filter will influence normal usage of the machine.
Remember to clean it once every two months.
On models RTT 2101WSU-19,RTT 2111WS-19.
off the overflow filter.
1.Take
Nip the elastic fixing claw and pull in the direction of the
arrow to remove (as demonstrated in the figure to the right).
the overflow filter.
2. Clean
Clean the lint around the filter and flush with tap water.
3.Re-install the overflow filter.
1) Install the corrugation pipe.
2) Attach the mounting plate at the bottom of the filter onto
the valve cover.
3) Hang the hook on the left upper side.
4) Push in the upper part.
On models RTT 261WSU-19,RTT 271WS-19.
1.Take off the overflow filteras shown in the figure.
Nip the elastic fixing claw and pull it in the direction
of the arrow to take it off.
the overflow filter.
2.Clean
Clean the lint around the filter and flush with tap water.
3.Re-install the overflow filter.
1) Install the corrugation pipe.
2) Attach the mounting plate at the bottom of the filter into
the valve cover.
3) Hang the hook on the left upper side.
4) Push in the upper part.
Cleaning the unit
Wipe the entire unit with a

soft dry cloth.
Use neutral detergent to wipe

if the machine is excessively
dirty.

Do not apply water directly
when cleaning.
Alcohol
13





Thinner
Petrol
After washing, disconnect the water intake hose.
Do not store water in the machine for long
periods of time. Drain the water immediately after
each use.
Pull out the power plug and hang up the power
cord.
Hang up the drain hose. Wipe off water drops on
the surface and inside the machine with a clean
soft cloth.
Open the cover of the wash cycle compartment
and the inner/outer covers of the spin cycle
compartment for a short period (about one hour),
then close them.
Elastic fixing claw
Hook