Candy RTT 261WSU-19 User Manual page 11

Mid-wash spin cycle
1. Put the laundries into the spin tub evenly and smoothly.
2.Spin：
(1) Distribute the laundry into the spin tub smoothly and evenly.
Note: the gland must be inserted properly even if the laundry quantity is small.
Push
Proper
(2)Close both the inner and outer covers of the spin tub.
(3) Spin for 1-2 minutes.
3.Run the foam-removing spinning.
(1) Open the outer cover of the spin tub.
(2) Set the water-filling selector control
rod at the "SPIN" side. Fill water for
about 1 minute.
If the water quantity filled is too large,
the water may flow out from the wash
tub side. Please twist the water tap to
limit the water filling.
(3) Close the outer cover of the spin tub.
Spin for 1-2 minutes.
Note:
The energy test program was performed using the STANDARD cycle :
fill in the water at 25℃ up to the highest water level,after Standard wash 10min,
Drain,Spin twice,each for 5min,5min rinse with the highest water level,Drain,
Spin twice,each for 5min.
Gland
The laundry
is slanted.
Outer cover of
The spin tub
Inner cover of
The spin tub
Push
Proper
No gland
TOR
10