Table of Contents
Advertisement
For more information, go to http://pic.dhe.ibm.com/infocenter/flexsys/information/index.jsp.
Navigate to IBM Flex System Information > Management Devices and Solutions >IBM Flex System
Chassis Management Module > Using the Web interface > Web interface options > Chassis
management options.
NOTE
Certain configuration settings are not restored to their default values when the request to restore
factory default settings is initialized from the CMM. See
Removing or replacing the switch
1. Before removing a switch from the chassis, read the following safety information:
2. Disconnect any cables from the switch that you are removing. For additional information about
3. Pull the release latches out from the switch, as shown in
4. Slide the switch out of the bay and set it aside.
5. Replace the removed switch with either another switch or a filler panel. You must complete this
6. If you installed another switch in the bay, reconnect the cables that you disconnected in
7.
8. Establish a connection to the CMM. For more information, see
Introduction
•
"Safety"
on page vii
•
"System reliability guidelines"
disconnecting cables, see
and the documentation that comes with the cables and optional network devices to which the
cables have been connected. For the locations of the connectors on the chassis, see the
documentation that comes with the chassis.
moves out of the bay approximately 0.6 cm (0.25 inch).
step within 60 seconds.
Attach any additional cables that are required by the switch. For additional information about
connecting cables, see
"Installing and removing an SFP+ or QSFP transceiver"
and the documentation that comes with the cables and optional network devices to which the
cables have been connected. For the locations of the connectors on the chassis, see the
documentation that comes with the chassis.
Install SFP+ and QSFP transceivers where appropriate. For safety information and instructions,
see
"Installing and removing an SFP+ or QSFP transceiver"
SSH"
on page 30.
on page 9
"Installing and removing an SFP+ or QSFP transceiver"
Managing the switch
Table 9 on page
32.
Figure 2 on page
12. The switch
on page 13.
"Connecting to the switch over
2
on page 13,
step
2.
on page 13,
35
Advertisement
Table of Contents
