Step 7: Test And Troubleshoot - Extron electronics MLC Plus 84 D Setup Manual

MLC Plus 84 D • Setup Guide (Continued)
Step 5: Set up the MLC Plus 84 for Network Communication
Connect the PC that you will use for setup and the
1.
MLC Plus 84 to the same Ethernet subnetwork. For
LAN connections for the MLC, see
— LAN (Ethernet) and PoE
Start Global Configurator and use the Toolbelt feature
2.
of the software (or stand-alone Toolbelt software) to
set the IP address, subnet, gateway IP address, DHCP
status, and related settings. Network setup is essential
prior to configuration. Use the flowchart at right as a
guide to setting up the controller for network use.
NOTE: When setting up DHCP during network
configuration or if using a host name instead of
an IP address during project recovery, the user
must enter a qualified host name (HostName.
Domain).
For example: somename.somedomain.com.
Step 6: Configure the MLC Plus 84 Controller
The most basic steps are outlined below in the recommended order.
NOTE: See the Global Configurator Help file as needed for step-by-step instructions and detailed information. The help file
for GC includes an introduction to the software, and how to start a project and configuration.
Using GC, create a new GC Plus or GC Professional project and configure the controller and any installed IP Link Pro
1.
devices. The configuration tells the controller how its ports function; how to control other products; what to monitor; when to
do things; and whom to notify, how, and under what circumstances.
Configure ports on the controller.
a.
Select device drivers and link them to each assigned serial, IR, or Ethernet port.
•
Configure settings (serial protocol, relay behavior, digital input, volume control settings) as needed.
•
Set up monitors, schedules, macros, and local variables.
b.
Set up the front panel buttons: assign appropriate commands and actions, macros, timers, local variables, monitors, or
c.
schedules to the buttons.
Save the project.
2.
Build and upload the system configuration to the controller.
3.

Step 7: Test and Troubleshoot

Test the system. See the MLC Plus 84 Series User Guide for an outline of the system testing and troubleshooting procedure.
1.
Make adjustments to wiring or configuration as needed. Remember that the rear and side panel ports will not be accessible
2.
after the controller is mounted.
Step 8: Complete the Physical Installation
Mount the unit to a wall or furniture (see
8
Control and Power
on page 5.
Mounting
on page 9).
Network Communication Setup,
Connected/Online Method
Connect the controller and PC to the same LAN and apply power.
Open the Toolbelt utility in Global Con gurator.
Use Toolbelt to display a list of MLC Plus 84 units and all other
IP Link Pro devices connected to the network.
Using the MAC address, locate the desired device
in the list and select it.
Enable DHCP or you must type in the IP address, subnet address,
and gateway, then con gure other network settings as needed.
Network Setup, Online Method
Figure 10.